Cisco 300-115 Dumps Implementing Cisco IP Switched Networks
Cisco 300-115 Exam:
As you get ready for the Cisco 300-115 exam, you ought to be capable of using theoretical data in real-world troubleshooting and networking issues. It's very easy to pass the exam with the assistance of the study guide. In the last few years, an increasing number of people decide to take Cisco 300-115 certification exam.
If you pass 300-115 exam and would like to acquire other subjects we may give you a discount too. Go with total confidence knowing you've studied hard and passed that exam. When it regards the Cisco 300-115 exam material is very important. The Cisco 300-115 certification exam is the important exam that provides expertise in IT.
When you pass the Cisco 300-115 exams you will secure a great start on your career. Just mark a date that you'll be prepared to take the CCNA exam. If you would like to take the CCNA exam with no expert experience, it's possible to accomplish this, and lots of students accomplish the exam successfully without practical experience. There are many ways to prepare for the CCNA exam.
By means of to the point Cisco 300-115 Braindumps you can readily ready the exam. Tell yourself you will conquer the exam. Certification exams go beyond training by offering a measurement of wisdom and skills.
Cisco 300-115 Exam Questions and Answers:
Question: 1
Which statement describes one major issue that VTP
can cause in an enterprise network when a new switch is introduced in the
network in VTP mode server?
A. It can
cause network access ports to go into err-disabled state.
B.
It can cause a network-wide VLAN configuration
change if the revision number on the new switch is higher.
C. It can
cause a network-wide VLAN configuration change if the revision number on the new switch is lower.
D.
It can cause routing loops.
Right Answer: B
QUESTION 2
A network administrator configures 10 extended
VLANs ranging from VLANs 3051 to 3060 in an enterprise network. Which version of VTP supports these extended VLANs?
A. version 1
B. version 2
C.
version 3
D. VTP does
not recognize extended VLANs.
Right Answer is C
QUESTION 155
An engineer is configuring an EtherChannel between
two switches using LACP. If the EtherChannel mode on switch
1 is configured to active,
which two modes on switch 2
establish an operational EtherChannel? (Choose
two.)
A. active
B.
auto
C. desirable
D. on
E. passive
Comments
Post a Comment